Discussion about making bushwalking-related equipment.
Fri 03 Sep, 2021 11:00 am
Thought the crafty people of the forum might know this.
I'm after a attachment for a tent pole. It's the plug with nail that is used to push into tent eyelets.
I need one for a pole with diameter of 150mm
It's the sliver plug in below photo.
Any idea where I could source? Looked at the tier gear website but couldn't see anything.
- Attachments
-

Fri 03 Sep, 2021 11:09 am
What diametre?
Fri 03 Sep, 2021 11:19 am
https://tentpoletechnologies.com/produc ... p-tie-off/https://tentpoletechnologies.com/produc ... p-tie-off/If it's smaller in diametre I may have one floating around somewhere
Postage form the USA is both slow and very expensive at the moment
Fri 03 Sep, 2021 11:31 am
Many thanks MD
Tent pole is 150mm diameter
Fri 03 Sep, 2021 11:56 am
That's 6inches; a tree trunk
I'd believe 15mm for a bushwalking tent which is the 0.625inch pole.
Fri 03 Sep, 2021 12:13 pm
Moondog55 wrote:That's 6inches; a tree trunk
I'd believe 15mm for a bushwalking tent which is the 0.625inch pole.
Hey I like my tent poles to be strong enough to withstand anything ok...
but of course your correct. 15mm is the diameter of the pole.
Fri 03 Sep, 2021 12:29 pm
If you decide to get what you need from TPT I need a couple of items, happy to split postage costs and sending them to me in Geelong can be done with letter rate postage by putting cardboard on both sides and sticky tape
Fri 03 Sep, 2021 6:06 pm
Thanks MD.
Considering the long delays for US shipping for anything other than a $$$ courier at the moment I'm probably going to go with a backup solution. But if you or anyone else knows where they can be sourced in Oz I'd be keen to know.
Sat 04 Sep, 2021 4:32 pm
Well I suppose you could buy an 8.6mm plug from Ansco and play around with glue/filler and such.
https://www.ansco.com.au/End-Plug-Tie-O ... ep340t.htmEpoxy doesn't work too well with the alloy of the poles tho but silicon based Superglue might work, a bit fiddle as I think it might take 3 sleeves to fill in the space, I may have some thick walled aluminium tubing that might be a slip fit inside 15mm tube.
Mon 06 Sep, 2021 4:22 pm
I reckon there would be folks around who have clapped out tents and poles with one of these bits. A FaceBook post on an outdoor gear or bushwalking page, a tip shop visit?
© Bushwalk Australia and contributors 2007-2013.