Bushwalk Australia

Hi all, my S2S air mat sprung a leak/weld/seam a while ago and before i threw it out, just wondering for other repair ideas (most ive found are from US and have US products not available here).

S2S/snowys were great and replaced it with a new one which I use, just looking to save on landfill.

Ive tried the patch and also some gorrila tape. Photos below show good tape adherence but the air is still escaping and creating air pocket which will fail.

Thoughts, tips, ideas?
Thank you
Shaun

Warranty issue. Contact S2S about the failed weld

Thanks Moondog, already done and have my replacement, just trying to see if any way this one can be saved from landfill

You did well to find it. I couldn't find the leak in mine. They had an issue with the welds on some of the earlier batches, and they have fixed it now. You could fix that leak but you'll probably find another will pop up.

Bicycle tube patch?
Even if it works, would you trust it enough to take it anywhere?